COMPARISON OF CUT AND FILL VOLUME USING PHOTOGRAMMETRIC MEASUREMENT AND TOTAL STATION MEASUREMENT

Authors

  • Riko Maiyudi universitas negeri padang
  • Fajri Ananda Universitas Negeri Padang
  • Yozi Mingsi Anaperta Universitas Negeri Padang
  • Andres Melbaral Universitas Negeri Padang

DOI:

https://doi.org/10.57265/georest.v1i2.7

Keywords:

Comparison, Photogrammetry, Total Station

Abstract

Survey activities at the time of mine exploitation  aim to map the  progress of  the mine and to determine the total volume of overburden   and coal that has been mined.     Currently,  the work of  mapping surveys  has begun to be replaced by observations of recorded data  without touching the object or  aerial shooting using aircraft  or called   photogrammetry . The purpose of  this study was to determine the   difference  and difference in volume of autogrammetric processing   with volume from  survey  processing using total stations. From  the volume results obtained from the  photogrammetric measurements, it will be reduced by the total station survey volume  which is considered  correct,   which is  441,404,769 BCM.     The difference between the Cut and Fill Volume of PIT A   using  Drones and the Volume of Surveys using Total Station is 166,655,453 BCM or around  37.76%. From  the difference in the volume of Cut and Fill   photogrammetry using each  number of  GCP  points with the  volume  of Cut and Fill survey total station it can be concluded that the   more the number of points   GCP then the volume will be closer to the survey volume using Total Station.

References

Ferdiansyah Novriza, Roni Agusmaniza. 2020. Pemetaan Topografi Menggunakan Total Station Pada Komplek Sekolah Terpadu Teuku Umar Aceh Barat. Akademi Komunitas Negeri Aceh Barat. Vocatech: Vocational Education and Technology Journal 2, 1 (2020): 41-48.

Syarifa Naula Husna, Sawitri Subiyanto, Hani’ah. 2016. Penggunaan Parameter Orientasi Eksternal (Eo) Untuk Optimalisasi Digital Triangulasi Fotogrametri Untuk Keperluan Ortofoto. Program Studi Teknik Geodesi Fakultas Teknik Universitas Diponegoro. Jurnal Geodesi Undip.

Zulkadri A Hasim, Moch. Abdul Basyid. 2021. Kajian Perbandingan Digital Elevation Model (Dem) Uav Dengan Digital Elevation Model (Dem) Topografi (Studi Kasus: Pt. Torganda Kawasan Industri Lubuk Gaung Tanjung Penyembal – Sungai Sembilan Kota Dumai). Seminar Nasional dan Diseminasi Tugas Akhir 2021.

Edy Nursanto, Faishal Insanul Jamal, Nur Ali Amri. 2018. Analisis Produksi Pada Kemajuan Tambang Menggunakan Metode Fotogrametri UAV (Unmmaned Aerial Vehicle) di Kuari Batu Gamping PT Semen Indonesia (Persero) Pabrik Tuban Jawa Timur. Jurusan Teknik Pertambangan, Fakultas Teknologi Mineral, UPN “Veteran” Yogyakarta. Jurnal Teknologi Pertambangan Vol. 4 No. 2 Periode September 2018 - Februari 2019.

Yulia Savira Rachma*) , Yudo Prasetyo, Bambang Darmo Yuwono. 2018. Analisis Akurasi Ketelitian Vertikal Menggunakan Foto Udara Hasil Pemotretan Pesawat Tanpa Awak Untuk Pembentukan Digital Terrain Model (Dtm). Departemen Teknik Geodesi Fakultas Teknik Universitas Diponegoro. Jurnal Geodesi Undip.

Iqbal Yukha Nur Afani*) , Bambang Darmo Yuwono, Nurhadi Bashit. 2019. Optimalisasi Pembuatan Peta Kontur Skala Besar Menggunakan Kombinasi Data Pengukuran Terestris Dan Foto Udara Format Kecil. Departemen Teknik Geodesi Fakultas Teknik Universitas Diponegoro. Jurnal Geodesi Undip.

Escolastico Fortunato Soares Sequeira Alves 2019. Perbandingan Antara Dem Foto Udara Dengan Dem Topografi (Studi Kasus: Kecamatan Lowokwaru, Kota Malang, Jawa Timur). Skripsi thesis, ITN MALANG.

Bambang Rudianto. 2011. Analisis Pengaruh Sebaran Ground Control Point terhadap Ketelitian Objek pada Peta Citra Hasil Ortorektifikasi. Jurusan Teknik Geodesi – FTSP Institut Teknologi Nasional, Bandung. Jurnal Rekayasa Intitut Teknologi Nasional.

Drone DJI Mavic Air 2s. Fitur Dji Mavic Air 2. Diakses 5 Maret 2022. https://www.plazakamera.com/shop/dji-mavic-air-2/.

Total Station Sokkia FX-101. Fitur Total Station Sokkia FX-101. Diakses 25 Maret 2022. https://dndsurvey.id/p/total-station-sokkia-fx-101/.

Rochmadi, Sunar. 1993. “ Perkembangan Teknologi Pemetaan dan Kaitannya dengan Pendidikan” Cakrawala Pendidikan : Nomor 1, Tahun XII.

Soendjojo, Hadwi; Akhmad Riqqi. 2012.

Kartografi. Penerbit ITB Bandung

Purworahardjo, U.U, (1986), Ilmu Ukur Tanah Seri A – Pengukuran Horisontal, Jurusan Teknik Geodesi, FTSP, ITB, Bandung.

Yulianto, W. (2003). Aplikasi AutoCAD 2002

untuk Pemetaan dan SIG. Jakarta: PT. Elex

Media Komputindo.

Downloads

Published

2023-02-04

How to Cite

[1]
R. Maiyudi, Fajri Ananda, Yozi Mingsi Anaperta, and Andres Melbaral, “COMPARISON OF CUT AND FILL VOLUME USING PHOTOGRAMMETRIC MEASUREMENT AND TOTAL STATION MEASUREMENT”, georest, vol. 1, no. 2, pp. 1–3, Feb. 2023.

Issue

Vol. 1 No. 2 (2022): Georest

Section

Articles

License

Copyright (c) 2023 Georest

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Geo-Rest Journal provides open access to anyone so that the information and findings in these articles are useful for everyone. This journal's article content can be accessed and downloaded for free, free of charge, following the creative commons license used.

Creative Commons License
Geo-Rest: GeoScience, Remote Sensing and Technology is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.